Hillclimb titanium car wheel bolts and nuts
I’m back to blogging! These are a set of titanium wheel bolts and nuts for a hillclimb car. I made them earlier in the year along with a couple of shed loads of other bits you will see over the next few weeks.
Read Morewebsite works
Please bare with me whilst the work on this site is completed. I’ve got lots to show you, although i can post pics now i’d rather wait until the layout is sorted and everything is looking good.
Read MoreWebsite development
My website is currently having some work done on it, so its messing about with the images and layout for a while till its all done, then it should settle down again. Part of the work is to post pages devoted to customers bikes, so if you want a page to show off your bike then email me with some pics.
Read MoreHonda SP2 bottom yoke titanium pinch bolts
These are the bottom yoke pinch bolts for a Honda SP2 made from titanium. I always scallop the top out of bolts as standard (unless asked not to). You’ll see sometimes i make race spec bolts with holes drilled across the flats for lockwire, this is an optional extra which does increase the cost as its quite a lot more work setting up to do it.
Read MoreSuzuki GSXR1000 K4 titanium rear wheel spindle
Here’s a titanium rear wheel axle for a Suzuki GSXR1000 K4 i made recently. its a big un. I don’t know if the solid end at the thread is standard of if it was just my customer requirement, but it meant it was bored all from the head end which is always a fun afternoons work!
Read MoreYamaha RD350 titanium wheel and swinging arm spindles
Here’s a set of titanium spindles for the wheels and swinging arm of a Yamaha RD350. skinny little blighters but nice to produce.
Read More
Recent Comments