1/2″-M12 titanium Matchless engine mounting studs

These engine mounting studs are 380mm long. Happily the engine plates and castings are bored 1/2″ so I left the shaft full diameter and turned M12x1.25 threads on the end to match Probolt flanged nyloc nuts. It would have been incredibly difficult to turn it down to 12mm over that distance leaving a good and accurate finish.

Matchless titanium 1/2"-M12 engine mounting stud
Matchless titanium 1/2"-M12 engine mounting stud
Matchless titanium M12x1.25 engine mounting stud thread
Matchless titanium M12x1.25 engine mounting stud thread

Leave a Reply